SRL stat sig

[Sll]

I've searched around but I cant seem to find a tut on making a SRL stat sig, could anyone tellme how or link me?

[StK Squenc]

You dont need a tut to make a srl stat sig....lol it's very easy to make one. If u still can't make one after i tell you how to then don't bother to make one or try and figure it on you own

On the left hand side if u go to the SRL Forum Homepage...You will see 3 tabs The Community,Official Srl, and Contact Zone. Under Official SRL You will see a link that says SRL Stats. Click on it and wait for page to load. When you get thier. Thier will 1 tab that says SRL Stats. Look for the one that says Register. Click on that one because now u have to Register Your self as Part of SRL Stats. When you click on it you will have to fill out all the information. Congrats your now registered. they will give u a id and a password. Go to scar and open Setup SRL. [Note you have to have the latest version of SRL You can get it here on this site.] Now click run and wait till the screen pops up. Enter your id(the number they gave u) and the password they gave u. Push Save or Ok.(Dont know the button). Now go back to http://www.fenjer.com/adnan/SRLStats/
and enter you SRL id. Now copy link and put in sig.

See very simple.

[Sll]

Thanks

[StK Squenc]

np i see that it works ...Your sig is working right..

[Harry]

mine won;t work... i gots all the code but its not updating...

plz help... if i get it working, don't reply lol

[Hey321]

what are you putting for ID?

[stupedspam]

does it show it in the "preview sig" place becaues when i did it it didnt show it...
EDIT: NVM i found problem

[Drew_Dawg]

the srl sig ownz
what was the problem?

[YoHoJo]

mine won;t work... i gots all the code but its not updating...

plz help... if i get it working, don't reply lol

Use a script that has SRL Sig compatibility.
Fill in a Id Number and Password in the consts and your good to go.