PDA

View Full Version : PLC Programming



Bonfield
04-04-2012, 01:16 AM
I'm learning about plc's just wondering if anyone here has done anything like it and can post any helpful information

If it helps the plc we are using is a Mitsubishi

ShawnjohnSJ
04-04-2012, 05:54 AM
I have absolutely no experience with PLC's but I know C++, are there any programming questions I can try and help you with or are you looking for a different kind of help?

wantonman
04-08-2012, 01:47 AM
hmm looks like you can get some assistance, here check out this site lots of information on probably about anything modifying!

http://hackaday.com/

Frement
04-08-2012, 01:57 AM
If it has a C++ compiler, perhaps you could try searching for that?

I've only done some PIC programming, and that was with ASM. But I hear you're able to code with C++ and then upload the program to the chip also.

Main
04-08-2012, 04:36 AM
so is this like ecu programming? Just search up the engine but it would be hard.

We did it for honda cbr 600 and we had to contact them to get the manual.

PIC is microcontroller but i guess you could use that as vehical aswell.

wantonman
04-08-2012, 06:07 AM
main you familliar with ecu mods? if you do your pro... apparently with newer cars now today its a totally different system nd the golden erra of ecu modding lived on in i think 1985-2002... well urban street undergound at least...

JuKKa
04-08-2012, 08:22 AM
i've done quite alot of mitsubishi PLC, just ask and i just might be able to help.

its that "ladder" diagram, right?