Extensions not showing up

[furikazashi]

I want to be able to keep simba installed on a flask memory card (ssd card, microsd card, or sd card) So i move the entire installation directory from simba over to it and it runs fine but none of the extensions show up unless i run it from its original area. IS there a way I can fix this so that I can install it fully to the card? ((upon writing this I'm about to try to set the installation up itself straight to the card in hopes of a workaround and will updates my findings, thanks)

[furikazashi]

installed straight to sd card this time and ran from same computer, everything shows up and works. plugged into next computer, extensions doesn't show anything

[Abu]

If I'm correct just open up Simba and just go to View -> Extension Menu and make sure the entensions are enabled.

Then View -> Extensions to have them show up

[litoris]

You need to change the paths in the settings.xml file. If you don't want to bother with that or if you don't know how to set the correct paths, re-download simba and set it up onto the flash drive. Then you can just copy and paste the scripts into the scripts folder.
Edit: Just read your seconds post, that's probably because in one computer your card gets the directory name F: for example, and E: in the other one.

[Sex]

Yeah just delete settings.xml everytime you run it on a different computer. Or modify yourself..

[furikazashi]

Thats alot everyone, I did confirm that i can edit the settings.xml file or go inside the program and edit the path from there. I did also take notice that the flask drive is a different letter on the alternate machine (long story on somethin i messed up and will definitely fix seeing how annoying it is to me) but with that being said just to go a step further, is it possible to add two paths for the scripts or will it only accept one path entirely. Thanks again
-Furi

[Sex]

I don't know, but I would like for them to be relative paths rather than absolute paths..